![]() Strict inspection after the separation of impurities in materials.ģ. ![]() Excessive heating of the back using the previous materials. PET or other heat-sensitive plastic appear impurities.Ĭheck the source of impurities, especially with PET manufacturing and conveying plastic pipe part.Ģ. The hot runner mold aggregates tube completely remove and clean.ġ. Wall injection molded too thin, so that plastic flow is not sufficient to pass through, so it causes no degradation.Ĭheck the correctness and consistency of wall thickness, if necessary, will be modified. Mold and nozzle should be removed and thoroughly cleaned.ģ. Use a correct type of screw design in the process of plastic. ![]() Use minimum back pressure and the correct use of the screw surface speedĦ. Using the incorrect screw surface speed and back pressure, causing the molten plastic over cut. Reduce the cycle time to increase plastic that is passed by the cylinder device.ĥ. Check the flow rate if its sufficient for cooling the hopper locking device, adjust the flow rate if necessary.Ģ. Reduce fire zone melt temperature in a feed tank. Plastic enters the mould cavity too fast causing excessive shear polymer.ġ. Use open or direct type nozzle to replace opening and closing nozzle.Ĥ. Check whether the nozzle is located correctly in injection cylinder.ģ. ![]() cylinder and screw should be removed and thoroughly clean the surfaces in contact with the polymer melt.Ģ. Plastic material traps in the cylinder device's deadĪrea or stagnant area, causing it to stay too long in the highġ. Use cleaning compounds or high molecular weight PMMA material to clean the injection cylinder unit.Ģ. The last production of degradable plastics materials in theĬylinder, screw, valve adapter maybe curing inside the aggregate hot Spots and stripes still visible even the molding parts have the correct color.ġ. 3) Bubbles (Or Steelyard balance : stranded gas)ĥ) Plastic injection molding machine of mucosaġ0) Injection molded parts does not shrinkġ7) Injection molded parts size differences ![]()
0 Comments
Leave a Reply. |